#Fxfactory 4.1.2 serial plus
(In this sense the numeric type is more akin to varchar( n) than to char( n).) The actual storage requirement is two bytes for each group of four decimal digits, plus three to eight bytes overhead. Thus, the declared precision and scale of a column are maximums, not fixed allocations. Numeric values are physically stored without any extra leading or trailing zeroes. Then, if the number of digits to the left of the decimal point exceeds the declared precision minus the declared scale, an error is raised. If the scale of a value to be stored is greater than the declared scale of the column, the system will round the value to the specified number of fractional digits. Note: The maximum allowed precision when explicitly specified in the type declaration is 1000 NUMERIC without a specified precision is subject to the limits described in Table 8-2. If you're concerned about portability, always specify the precision and scale explicitly.) (The SQL standard requires a default scale of 0, i.e., coercion to integer precision. A column of this kind will not coerce input values to any particular scale, whereas numeric columns with a declared scale will coerce input values to that scale. Without any precision or scale creates a column in which numeric values of any precision and scale can be stored, up to the implementation limit on precision. The precision must be positive, the scale zero or positive. To declare a column of type numeric use the syntax: NUMERIC( precision, scale) Integers can be considered to have a scale of zero.īoth the maximum precision and the maximum scale of a numeric column can be configured. So the number 23.5141 has a precision of 6 and a scale of 4. The scale of a numeric is the count of decimal digits in the fractional part, to the right of the decimal point. We use the following terms below: the precision of a numeric is the total count of significant digits in the whole number, that is, the number of digits to both sides of the decimal point. However, arithmetic on numeric values is very slow compared to the integer types, or to the floating-point types described in the next section. It is especially recommended for storing monetary amounts and other quantities where exactness is required. The type numeric can store numbers with a very large number of digits and perform calculations exactly. The following sections describe the types in detail.
#Fxfactory 4.1.2 serial full
The numeric types have a full set of corresponding arithmetic operators and functions. The syntax of constants for the numeric types is described in Section 4.1.2. Up to 131072 digits before the decimal point up to 16383 digits after the decimal point
0 kommentar(er)
